Malndi
Well Known Member
Going over my recently purchased RV6A with an AP (Aus equivalent of a DAR) we were both mildly concerned about the lower rod end bearing on the flap linkage. While the upper rod end bearing is nicely secured the lower end uses a bearing with an integral 1/4" stud, ie no place for a safety washer.
After consulting the preview plans I found that a CM-4S bearing with integral stud is indeed the correct fitment at this location. But it just doesn't look adequate for such a high stress component.
Is there another way of securing the lower end of the flap linkage, or am I unduly concerned? Appreciate your thoughts.
Mal
[/url][/IMG]
After consulting the preview plans I found that a CM-4S bearing with integral stud is indeed the correct fitment at this location. But it just doesn't look adequate for such a high stress component.
Is there another way of securing the lower end of the flap linkage, or am I unduly concerned? Appreciate your thoughts.
Mal
![flap_bearing.jpg](/community/proxy.php?image=http%3A%2F%2F%5Burl%3Dhttp%3A%2F%2Fpostimg.org%2Fimage%2Ftbcr25w2b%2F%5D%5Bimg%5Dhttp%3A%2F%2Fs13.postimg.org%2Ftbcr25w2b%2Fflap_bearing.jpg&hash=e43b574dc8737a7116f015512e98c8e4)