[drill_and_buck]

I am looking for information on how to install the thin washers/spacers on the flap motor spindle. My flap motor is apart in pieces. I reviewed the Van's .pdf for flap motor maintenance but it does not specify how to install the four spacers. It only states "there are several washers on the shaft and that these need to be installed in the order they came out".

For those who have cleaned their flap motor, what order do the spacers on the end of the spindle go in? There are two thin stainless and two thicker black spacers.

Thanks in advance for your replies.

Mike

 

[Bavafa]

Just wondering if you ever find out the order of which these washers would go in? I just pulled mine apart to clean and it all seem to be very clean only now I have doubts about the order of the washers that they go in.