Okay,
After following the instruction manual and drilling a hole for the flap rod and then elongating it to allow for full flap travel, I ended up with this:
What should I do now?
A) Nothing
B) Add rivets (in yellow) to restore strength to the rivet line
C) Drill out the rivets in red, add a small doubler and replace rivets as needed
Dave A.
6A build
After following the instruction manual and drilling a hole for the flap rod and then elongating it to allow for full flap travel, I ended up with this:
![flaphole1.jpg](/community/proxy.php?image=http%3A%2F%2Fpages.suddenlink.net%2Ftismuoi9%2Fflaphole1.jpg&hash=7066990a364bc8bd48831ba6c059641e)
What should I do now?
A) Nothing
B) Add rivets (in yellow) to restore strength to the rivet line
C) Drill out the rivets in red, add a small doubler and replace rivets as needed
![flaphole3.jpg](/community/proxy.php?image=http%3A%2F%2Fpages.suddenlink.net%2Ftismuoi9%2Fflaphole3.jpg&hash=0cf9d950baf51e6368e419ba0a6098ae)
Dave A.
6A build