BSwayze
Well Known Member
I'm currently fitting the flaps and enlarging the hole in the fuselage for the flap push rod. I've looked all through my drawings and the plans, and I can't find any notes about how much clearance to trim for on the inboard side of the flap where it meets up with the fuselage. Mine fit extremely close before trimming. There's no rubbing or anything detrimental as far as I can tell, but it seems to me there should be a bit more clearance. Did I miss it somewhere in the plans?
How have some of you finished this? Did you trim it, and how much clearance did you allow? Here's a picture as it is right now:
How have some of you finished this? Did you trim it, and how much clearance did you allow? Here's a picture as it is right now: