[Geico266]

I found this link to a step by step procedure for using the Loctite 290 to seal rivets. Using a vacuum to draw the Loctite in was interesting. Be VERY carefully to purge the tanks of all fumes before drawing tank air into a sparking motor. Also, the Loctite 290 seals better if used in warm temps, 80F +.

I thought I would start a new thread for future use.

http://www.seqair.com/skunkworks/Maintenance/TankLeak/TankLeak.html

 

[Geico266]

So far so good! The 2 weeping rivets are still sealed tight after 3 hours of flying.