[email protected]
Well Known Member
after pulling a few wires for the power and ground on the sykview... flipped the master, programed the power pin in the vp-50, flipped the switch... and the dynon logo came to life. very cool. with near giddy enthusiasm we looked on.

after a few moments the screen changed to show two large red x?s with ems fail and position fail... hmmm... no network light on the ems module so i unplugged the open ended cable to the adahars, that is not installed, and restarted. okay now we had a network signal but the red x?s persisted.
i could not figure out how to get into setup mode without the book... press and hold buttons 7 and 8...
enter setup mode, select network configuration, and configure. the dynon finds and registers all devices and sets up the initial screens. wow, this was really cool.

after a few moments the screen changed to show two large red x?s with ems fail and position fail... hmmm... no network light on the ems module so i unplugged the open ended cable to the adahars, that is not installed, and restarted. okay now we had a network signal but the red x?s persisted.
i could not figure out how to get into setup mode without the book... press and hold buttons 7 and 8...
enter setup mode, select network configuration, and configure. the dynon finds and registers all devices and sets up the initial screens. wow, this was really cool.