billytime1
Well Known Member
Making holes and thinking , has anyone used a sealant like pro seal to help keep any kinds of liquids from getting into the fuse floor board area, right at firewall and thinking of a small very thin amount of pro seal to make this possible.
And while on this area the firewall to angle metal row of rivets calls for subcut / draw dimple ? Its 040 bottom skin f672 ,,, would countersink the 040 be acceptable. I get that nesting is a bit better.. just a few questions I guess.
Thanks vaf community
I’m happier here than on tech support from vans mountain…
And while on this area the firewall to angle metal row of rivets calls for subcut / draw dimple ? Its 040 bottom skin f672 ,,, would countersink the 040 be acceptable. I get that nesting is a bit better.. just a few questions I guess.
Thanks vaf community
I’m happier here than on tech support from vans mountain…