Things are going well mostly but on my RV14A I have run into a problem with one edge only of my canopy. I think the aluminum bent slightly out and it protruding slightly so there is a very small gap. I need/want to cover it and yes it wont look perfect no matter what I do.
So would you in this case fill behind the gap and then glass over the top and just try to make it good enough, or perhaps cut a small diagonal corner off of the aluminum and then just glass it over? I guess bending it in place a little is also a possibility but I would still have a small gap behind it.
The pictures show what I am talking about better than the description.
Thanks!
![](/community/proxy.php?image=https%3A%2F%2Fi.ibb.co%2FzRcXL8H%2FIMG-7184.jpg&hash=fbb5bfd2bdddb9a7bdb29f0feb930bc4)
So would you in this case fill behind the gap and then glass over the top and just try to make it good enough, or perhaps cut a small diagonal corner off of the aluminum and then just glass it over? I guess bending it in place a little is also a possibility but I would still have a small gap behind it.
The pictures show what I am talking about better than the description.
Thanks!
![](/community/proxy.php?image=https%3A%2F%2Fi.ibb.co%2FLrhvBpM%2FIMG-7183.jpg&hash=510e539acc55f25ede715b61bf0bf9c7)
![](/community/proxy.php?image=https%3A%2F%2Fi.ibb.co%2FxHqjYxD%2FIMG-7181.jpg&hash=ed8f4909400a6425a4d019fe18525160)
![](/community/proxy.php?image=https%3A%2F%2Fi.ibb.co%2FTkgQPLC%2FIMG-7182.jpg&hash=79d9c09fa2087e3a77505841a3fc33f8)
![](/community/proxy.php?image=https%3A%2F%2Fi.ibb.co%2FzRcXL8H%2FIMG-7184.jpg&hash=fbb5bfd2bdddb9a7bdb29f0feb930bc4)