wirejock
Well Known Member
The plans and manual mention sufficient edge distance on both F796A and T405 Tank Attack Brackets before drilling.
There's no edge on F796A and if it were closed, would be short by about 1/16".
Question
Am I supposed to file the slot a bit deeper to get the meaasurement? If I do, it encroaches on the edge distance on T405. I dont see a reason since the part has a slot in it anyway.
What have others done here?
Edit...
It appears, if the F706A were closed, the edge distance would be correct.
Still, it would be nice to hear a second opinion.
There's no edge on F796A and if it were closed, would be short by about 1/16".
Question
Am I supposed to file the slot a bit deeper to get the meaasurement? If I do, it encroaches on the edge distance on T405. I dont see a reason since the part has a slot in it anyway.
What have others done here?
Edit...
It appears, if the F706A were closed, the edge distance would be correct.
Still, it would be nice to hear a second opinion.
Last edited: