wirejock
Well Known Member
Another question. I'm getting really gun shy with cutting long stuff. Shipping cost $$$.
F-786A,B&C J-stiffeners
The manual says cut them to length and prepare the ends. Ok.
The plans have length dimension. Ok.
There is a detail for F-786B-R Aft End Trim. Ok.
But the plans Note says, "trim to fit all F-786 stringers. Fore and aft conditions vary depending on the bulkhead. For best fit, note the angle between stringer and bulkhead and trim accordingly."
So do I cut the aft end per detail, on just the "B" stringer, cut the aft of each or leave them and cut them to fit on both ends?
And do I cut the length to plan or cut them long and do some magic later?
Frustrating.
F-786A,B&C J-stiffeners
The manual says cut them to length and prepare the ends. Ok.
The plans have length dimension. Ok.
There is a detail for F-786B-R Aft End Trim. Ok.
But the plans Note says, "trim to fit all F-786 stringers. Fore and aft conditions vary depending on the bulkhead. For best fit, note the angle between stringer and bulkhead and trim accordingly."
So do I cut the aft end per detail, on just the "B" stringer, cut the aft of each or leave them and cut them to fit on both ends?
And do I cut the length to plan or cut them long and do some magic later?
Frustrating.