s10sakota
Well Known Member
Should there be a third hole in the two F-728 pieces? These pieces get bolted on to the spar carry-through....
Notice on the pic (in red circles) there is a rivet hole in the spar box piece and the angle bracket that I had to fabricate, but there is no matching hole in the F-728 piece.
Since the F-728 is bolted on to the spar carry through (F-704?) it must be made to be able to remove it. If I drill the third hole and put a rivet through the F-728, the spar web, and the angle bracket, then the F-704 won't be able to be removed.
This is kind of difficult to explain typing, but hopefully you understand what I'm asking!
There's never any mention of drilling a third hole in this piece...
Notice on the pic (in red circles) there is a rivet hole in the spar box piece and the angle bracket that I had to fabricate, but there is no matching hole in the F-728 piece.
Since the F-728 is bolted on to the spar carry through (F-704?) it must be made to be able to remove it. If I drill the third hole and put a rivet through the F-728, the spar web, and the angle bracket, then the F-704 won't be able to be removed.
This is kind of difficult to explain typing, but hopefully you understand what I'm asking!
There's never any mention of drilling a third hole in this piece...