Michael Burbidge Well Known Member Dec 9, 2023 #1 I machine countersunk four holes, shown in the diagram, that were not suppose to be countersunk. Anyone make the same mistake? Do you think I can put AN426AD4 rivets in those four holes instead? Attachments Screenshot 2023-12-09 at 7.29.14 PM.png 132.6 KB · Views: 75
I machine countersunk four holes, shown in the diagram, that were not suppose to be countersunk. Anyone make the same mistake? Do you think I can put AN426AD4 rivets in those four holes instead?
rvbuilder2002 Legacy Member Mentor Dec 10, 2023 #2 Shouldn’t be a problem. 470s were spec’s there for build simplicity and there being no physical benefit to them being flush.
Shouldn’t be a problem. 470s were spec’s there for build simplicity and there being no physical benefit to them being flush.
Michael Burbidge Well Known Member Dec 10, 2023 #3 Thanks I can see that 470’s would be a little easier to install. But there should be room to install flush rivets. I’ll make sure that is the case before I start. Thanks!
Thanks I can see that 470’s would be a little easier to install. But there should be room to install flush rivets. I’ll make sure that is the case before I start. Thanks!
M mturnerb Well Known Member Dec 11, 2023 #4 I made the same mistake. My tech counselor (Vic Syracuse) said "BUILD ON". It was easy to install flush rivets and if I may say so it looks better! Last edited: Dec 11, 2023
I made the same mistake. My tech counselor (Vic Syracuse) said "BUILD ON". It was easy to install flush rivets and if I may say so it looks better!