HAL Pilot
Well Known Member
Aloha
Wondering about bolt snugness for these attachment points. I just drilled the 1/4 inch holes but the bolts have a little wiggle to them if I test fit them.
So I pulled out the calipers and the holes are nice 0.250 inches but the bolts are 0.247 so there is a bit of wobble when inserted. I am not an engineer but I would think the horizontal Stab attachment bolts should go in snug and not have any movement. Am I too paranoid here?
Wondering about bolt snugness for these attachment points. I just drilled the 1/4 inch holes but the bolts have a little wiggle to them if I test fit them.
So I pulled out the calipers and the holes are nice 0.250 inches but the bolts are 0.247 so there is a bit of wobble when inserted. I am not an engineer but I would think the horizontal Stab attachment bolts should go in snug and not have any movement. Am I too paranoid here?
Last edited:
