After 95 hours it is obvious to me that I have put the P1 headset jacks too far forward and as a result the headset lead is trailing in my way. I'd like to move the jacks back to the vicinity of my right elbow. Of course, the leads will need to be about 15 inches or so longer. I would prefer not to have to redo all the wiring from the radio to the jacks and would prefer just to extend the leads, which of course are "screened".
Is such a thing feasible or will I inevitably get an big increase in noise because of the inevitable break and short section of unscreened wire?? I had thought that the cores could be joined with crimps, and the screening connected by terminating using a presoldered ring and short length (may be 1 inch or so??) of say 22awg to join the two screened sections (I hope that's an adequate description).
Thanks
Chris
Is such a thing feasible or will I inevitably get an big increase in noise because of the inevitable break and short section of unscreened wire?? I had thought that the cores could be joined with crimps, and the screening connected by terminating using a presoldered ring and short length (may be 1 inch or so??) of say 22awg to join the two screened sections (I hope that's an adequate description).
Thanks
Chris