Not a big deal (except to me), but I trimmed the left side of my instrument panel 1/4" too far, I can easily adjust to make it look fine, but.... y'know. I was thinking I might be able to make a lip out of JB Weld (like I'd do with a bit of resin and filler if I was working with fiberglass), maybe put a thin piece of metal on the back to support it. Piece I need to add is only ~1.5" long, and is non-structural/load-bearing
The panel is going to be veneered, so the repair/extension will be covered up, thoughts about if this is possible?
TIA
The panel is going to be veneered, so the repair/extension will be covered up, thoughts about if this is possible?
TIA
Attachments
Last edited: