Electrogunner
Well Known Member
Anyone use the standard Vans supplied Vetterman exhaust with the Airflow systems AC compressor? Any fitment issues?
I installed the Airflow Systems A/C system in my RV-10, along with the Van's provided Vetterman exhaust with the Lycoming IO-540 with no interference between exhaust and A/C system.
Regards,
I'm building an RV-10 and have just rec'd the QB Fuselage. I'm wanting to install the AirFlow Systems AC. I'm wondering how the stock exhaust that comes with the Finishing Kit (seems from your comments that it is a Vetterman product?) avoids feeding the intake pod under the Fuselage? Feeding HOT exhaust into the condenser section would seem to be unwanted for lots of reasons.
There's a pic on the AirFlow Systems site for the Glasair II in flight that shows the exhaust trail stain from the co-pilot's side pipes feeding right into the belly scoop.
Also, I heard that installing this sooner rather than later would be of advantage. The tunnel is basically empty at this point. I'm thinking of limiting my Fuel Injection choices to basic Vans Lycoming options in order to not overly complicate the tunnel. Any input is appreciated!
Also, I heard that installing this sooner rather than later would be of advantage. The tunnel is basically empty at this point. I'm thinking of limiting my Fuel Injection choices to basic Vans Lycoming options in order to not overly complicate the tunnel. Any input is appreciated!
How far aft does the Intake get mounted? Does it interfere with putting the antennae below the rear seats?