Minor issue here and would just like to find out what others are using. I just overhauled my 0-320 in my 6A and during the reinstallation of the exhaust I noticed evidence of contact with the part of the engine mount that supports the nose gear strut. My AI-A&P buddy suggested Adel clamps at the effected area. This works but the padded clamps (Or at least the ones I found) are thick and make contact with the exhaust when I adjust for adequate spacing with the cowl. What I need is something thinner and not sensitive to heat so contact will be kept to a minimum. I have a buddy who uses fire sleave like what one finds on a fuel line. The would be heat tolerant and thin enough. I have also found some high temp (450F) fuel line on McMaster Carr. Is there anything else I should consider?
Thanks,
Kirk
Thanks,
Kirk