KiloFoxtrot
Well Known Member
Can you guys shed some light on an exhaust hanger installation.
I have a Vetterman trombone exhaust with mufflers installed on a Superior IO-360 with the cold induction. Between the header and muffler/tail pipe is a ball type socket. I assume this is primarily for movement absorption.
As the pipes exit the cowl keeping a good airgap for spacing, I tried to install the hangars to the back of the engine, and I can't get a straight shot, so I mocked up this installation. I would like to get some opinions of experience from you.
Am I going to run into problems doing it this way?
If you have an IO-360 with a Vetterman trombone exhaust, how did you do it?
Thanks
I have a Vetterman trombone exhaust with mufflers installed on a Superior IO-360 with the cold induction. Between the header and muffler/tail pipe is a ball type socket. I assume this is primarily for movement absorption.
As the pipes exit the cowl keeping a good airgap for spacing, I tried to install the hangars to the back of the engine, and I can't get a straight shot, so I mocked up this installation. I would like to get some opinions of experience from you.
Am I going to run into problems doing it this way?
If you have an IO-360 with a Vetterman trombone exhaust, how did you do it?
Thanks