Hi guys,
I have a Precision Silverhawk EX-5VA1 installed on my IO-375. Today was first engine start. I installed the mixture arm as per the indicated rick and lean direction on the schematic..... but I now note it says "standard rotation shown, alternate is opposite".
I now know that the mixture cable pushes the arm in the wrong direction. Rather than modify the geometry of my setup, can the servo be internally modified from alternate back to standard.
Hope this makes sense.
Thanks,
Dan
I have a Precision Silverhawk EX-5VA1 installed on my IO-375. Today was first engine start. I installed the mixture arm as per the indicated rick and lean direction on the schematic..... but I now note it says "standard rotation shown, alternate is opposite".
I now know that the mixture cable pushes the arm in the wrong direction. Rather than modify the geometry of my setup, can the servo be internally modified from alternate back to standard.
Hope this makes sense.
Thanks,
Dan