[email protected]
Well Known Member
i am satisfied with how the empennage fairing and closer strips are coming out but it sure has been quite a bit of work. the plans are really very weak here, or perhaps it is just that i haven't been looking at them much since moving past the firewall...
i have decided to forgo the rubber seal and screw hardware for the closure strip in favor of a close fit and rivets. from a bit of research here it looks like a common solution.
now that i am about wrapped up with the basic fiberglass work on the tail i wonder just how much fine finishing i should do, or defer to the 'professionals'... just how much interim finishing and painting should be done to adequately protect the tips and bits during the first 6 months to a year before paint? knowing that the painter will strip whatever i put on, off... a basic protective rattle can of 988 is what i am inclined to do...
hmmmm....
i have decided to forgo the rubber seal and screw hardware for the closure strip in favor of a close fit and rivets. from a bit of research here it looks like a common solution.
now that i am about wrapped up with the basic fiberglass work on the tail i wonder just how much fine finishing i should do, or defer to the 'professionals'... just how much interim finishing and painting should be done to adequately protect the tips and bits during the first 6 months to a year before paint? knowing that the painter will strip whatever i put on, off... a basic protective rattle can of 988 is what i am inclined to do...
hmmmm....