Brent Colvin
Well Known Member
Hello all,
I am finishing up elevator's. Plans call for countersinking E-702 so that it and E-709 can fit flush, allowing WD-605 to lay flat. This material is very thin, would be easy to countersink to much, would it be ok to just dimple these parts instead? Also, what is everbody using to put on stiffners before riveting to keep them from oil canning? Thanks in advance
Brent Colvin
RV7 emp
QB on the way
I am finishing up elevator's. Plans call for countersinking E-702 so that it and E-709 can fit flush, allowing WD-605 to lay flat. This material is very thin, would be easy to countersink to much, would it be ok to just dimple these parts instead? Also, what is everbody using to put on stiffners before riveting to keep them from oil canning? Thanks in advance
Brent Colvin
RV7 emp
QB on the way