marchudson
Well Known Member
Was wondering if anyone else ran into this issue? For reference, I'm on page 9-24 of the build manual. Step 9 says Secure the Trim Tab Pushrod to the ES-MSTS-T3-12A Trim Servo as shown in Figure 4. This consists of the pin with two washers the trim tab and a cotter key. There doesn't seem to be enough room to insert the cotter key. Before I go and remove some material from either the trim tab pushrod or the trim servo, I figure that asking the rest of the group what they did in this situation would be helpful. See the attached picture.
Never mind a lot has happened since last night, two fresh cups of coffee this morning
. I grabbed the wrong pin by mistake out of the supply drawer.
Never mind a lot has happened since last night, two fresh cups of coffee this morning
. I grabbed the wrong pin by mistake out of the supply drawer.
Last edited by a moderator:
