Robert M Well Known Member Mar 2, 2010 #1 I was wondering if anyone has put the manual elevator trim control some place other than the fuel selector valve mounting plate? Just toying with the idea.
I was wondering if anyone has put the manual elevator trim control some place other than the fuel selector valve mounting plate? Just toying with the idea.
Greg Arehart Well Known Member Mar 2, 2010 #2 Robert, I built a custom console and put mine in a slightly different place (just above the Andair fuel valve and below the throttle/mixture): Notice that my panel is probably among the cheapest in the business. Always have good airspeed, and my engine runs very consistently. [photo was taken before my panel was completely installed] The cable end is lying on the floor in this photo, but it's a standard length cable and fit my installation fine. cheers, greg
Robert, I built a custom console and put mine in a slightly different place (just above the Andair fuel valve and below the throttle/mixture): Notice that my panel is probably among the cheapest in the business. Always have good airspeed, and my engine runs very consistently. [photo was taken before my panel was completely installed] The cable end is lying on the floor in this photo, but it's a standard length cable and fit my installation fine. cheers, greg
hydroguy2 Well Known Member Mar 3, 2010 #3 Mine will be: Left side under the throttle quadrant, but I haven't finished mounting yet.