Allan Stern
Well Known Member
My elevator trim does not want to calibrate on the GX3. The trim works and goes up and down. I am pulling 5volts at the white/orange wire. The white/blue wire shows it is grounded. And the white/green indicates nothing.
When I go to calibrate the unit on the GX3 there is no voltage change as the unit travels up and down from the neutral to full up and full down.
Any ideas what I might look at? Thanks
RV 14A 140507
N507PW
Almost ready
When I go to calibrate the unit on the GX3 there is no voltage change as the unit travels up and down from the neutral to full up and full down.
Any ideas what I might look at? Thanks
RV 14A 140507
N507PW
Almost ready