Hey All
Just put on my elevators as per instructions ( horns are flush with stabs skins) drilled all holes and noticed my right trailing edge is about 1/4 inch lower than my left when looking down the edge. Been searching the forums and see that this does occur from time to time . Im going to get a laser and check for alignment. Ran string down from one elevator corner to other corner and i have no twist. With string taught makes it appear to be almost gone ( could be illusion). How many of you have seen this and what was your fix. I was thinking to having the drill hole welded and re-drilling with trailing edge straight by splitting the difference on the horns ( left slightly up 1/16" right slightly down 1/16". let me know of other any other solutions and if anyone had the same problem.
Thanks Much
Just put on my elevators as per instructions ( horns are flush with stabs skins) drilled all holes and noticed my right trailing edge is about 1/4 inch lower than my left when looking down the edge. Been searching the forums and see that this does occur from time to time . Im going to get a laser and check for alignment. Ran string down from one elevator corner to other corner and i have no twist. With string taught makes it appear to be almost gone ( could be illusion). How many of you have seen this and what was your fix. I was thinking to having the drill hole welded and re-drilling with trailing edge straight by splitting the difference on the horns ( left slightly up 1/16" right slightly down 1/16". let me know of other any other solutions and if anyone had the same problem.
Thanks Much