Wesflies
Active Member
I riveted the fiberglass tips on my left elevator. All was going well until I reached the last rivet. The predrilled holes on top and bottom of the trailing edge of the skin are directly across from each other. This means the first rivet went in great. Now, however, there is no room for the last rivet because the training edge of the elevator is too narrow for two rivets (one on top of the another) . Did this happen to anyone else? What do I do now? The right elevator predrilled holes are the same......I'm not going to rivet this one until I figure this out or get an answer. Thanks, Wes