AcezHi Active Member Feb 18, 2011 #1 Should have I ran some type of conduit before I closed up my elevators? Didn't give it much thought until I was mounting the servo.
Should have I ran some type of conduit before I closed up my elevators? Didn't give it much thought until I was mounting the servo.
Mike S Senior Curmudgeon Feb 18, 2011 #3 I just used snap bushings in the bulkheads as I went along. I used Deans 4 pin connectors, from the local R/C store, for hooking up the wiring, cheap, small, highly reliable, and well suited to the tiny wire used. There are photos and a write up on this thread. Hope this helps. Last edited: Feb 18, 2011
I just used snap bushings in the bulkheads as I went along. I used Deans 4 pin connectors, from the local R/C store, for hooking up the wiring, cheap, small, highly reliable, and well suited to the tiny wire used. There are photos and a write up on this thread. Hope this helps.
AcezHi Active Member Feb 20, 2011 #4 Thanks, I was a little worried after i realized I didn't address this before I closed up the elevator.
Thanks, I was a little worried after i realized I didn't address this before I closed up the elevator.