[Skint]

Having received my electric primer kit from Van's, there really is little guidance on the installation ie make your own bracket, wiring to panel etc
So where is a good place to place the solenoid? This would be for an 0-360, carb, 7a set up.
Looks like some angle attached to the firewall then there are threaded holes on the bottom of the solenoid to attach to the angle. I would assume a bunch of adel clamps to support the tubing runs and a push/start switch on the panel.
Guidance please!
Thanks

 

[apkp777]

I used a straight (steel) fitting and connected it to the gascolator. Looks good. Others have done the same.

 

[uk_figs]

switch

With respect to the switch if you have the boost pump you can wire to a 2 position switch where the 2nd position is momentary so you switch on the boost pump then hold the switch for a few second to prime. I have my switch between the throttle and mixture so it can be reched while holding the throttle.