Bayou Bert
Well Known Member
I think I shut my EIS down still in the config state.
I have been reading and no help there.
When it is powered up now I get the "Check Entries" and
below above the left button "next".
If I hit next, all the squares where numbers or letter would be displayed
go to dark pixels.
I tried to reboot and start over by holding down the right button and
then powering up and still get the "Check Entries"
Does anyone know how to reboot to factory settings so I can re config.
Right now when it powers up there is no communication with the EFIS "HXr"
until I hit the next button but no temps.
Any help greatly appreciated.
I have been reading and no help there.
When it is powered up now I get the "Check Entries" and
below above the left button "next".
If I hit next, all the squares where numbers or letter would be displayed
go to dark pixels.
I tried to reboot and start over by holding down the right button and
then powering up and still get the "Check Entries"
Does anyone know how to reboot to factory settings so I can re config.
Right now when it powers up there is no communication with the EFIS "HXr"
until I hit the next button but no temps.
Any help greatly appreciated.