High_Flyer
Well Known Member
Hello everyone,
Yesterday I installed the rollbar on my RV-7. I then dismanteled it and saw this:
Obviously there is an edge distance issue here with the hole on the F631A channel.
These are the holes through which the AN 509-10R10 screws are going in (see pic below). The edge distance inside is good as there is another strip of aluminum F631B-L. The The F631A aft channel where the mistake is located is sandwiched between two pieces.
Is that a problem??
Thanks and Merry Christmas to all.
Alain.
Yesterday I installed the rollbar on my RV-7. I then dismanteled it and saw this:
Obviously there is an edge distance issue here with the hole on the F631A channel.
These are the holes through which the AN 509-10R10 screws are going in (see pic below). The edge distance inside is good as there is another strip of aluminum F631B-L. The The F631A aft channel where the mistake is located is sandwiched between two pieces.
Is that a problem??
Thanks and Merry Christmas to all.
Alain.