Daida
Well Known Member
Out of SV Installation, concerning PIN determination.
Long story short:
What comes out from SV in the D37 harness as RX (e.g. PIN 3),
Has to go into the XPDR as TX ( PIN 7).
What comes out from SV in the D37 harness as TX (e.g. PIN 4),
Has to go into the XPDR as RX (PIN 5).
In general you can say:
Output/TX from a component, becomes Input/RX at the other end of the cable.
And vice versa.
Am i right, or wrong!
It is probably pretty easy, but i am confused.....
TX, Input, PIN, Output, PIN, D37,COM, RX, Input, PIN,.........whaaat !!!
Thanks for your "reset"!
Long story short:
What comes out from SV in the D37 harness as RX (e.g. PIN 3),
Has to go into the XPDR as TX ( PIN 7).
What comes out from SV in the D37 harness as TX (e.g. PIN 4),
Has to go into the XPDR as RX (PIN 5).
In general you can say:
Output/TX from a component, becomes Input/RX at the other end of the cable.
And vice versa.
Am i right, or wrong!
It is probably pretty easy, but i am confused.....
TX, Input, PIN, Output, PIN, D37,COM, RX, Input, PIN,.........whaaat !!!
Thanks for your "reset"!