[Anna]

Hey Guys!

Some questions to the Dynon Pitch Servo Installation:

- How to fix the Dynon Pitch Brackets at the fuselage? Would you prefer rivets, screws or don?t fix them anyway?
- Did you trim the stringers in the middle section or isn?t it more clever to trim the overdesigned pitch brackets (in the red marked section)?

[/url][/IMG]

- Did you use some AN426AD-4 Rivets (instead of AN470AD) with the left side of the F-635 Elevator Bell Crank to prevent the rivets from interference with the Servo?

[/url][/IMG]

Thanks a lot for helping!
Best regards
Anna

 

[Don Patrick]

3 links

Anna,

Here's 3 links for a source of reference.

Cheers,

Don

http://www.vansairforce.com/community/showthread.php?t=95884&highlight=dynon+pitch

http://www.vansairforce.com/community/showthread.php?t=81926&highlight=dynon+pitch

http://www.vansairforce.com/community/showthread.php?t=62638&highlight=dynon+pitch

 

[Walt]

I've installed a few of these. I would not trim the angles and I don't use a washer under the lwr/fwd bolt to provide a little extra clearance, works just fine. (I also installed solid rivets when I replace the brackets.)