Hi Guys,
Just hoping someone can provide some advise.
I am installing the Dynon engine sensors on my Lycoming IO-360 M1B.
The only probe I am unsure about is the oil temperature sensor.
I have installed this into the top port of the spin on oil filter adaptor. The sensor does not have a gasket and easily screwed into the port all the way without any resistance. I have applied some Permatex thread sealant before tightening the probe. Is this sufficient to ensure that it will not leak. All the other fittings that I have installed seemed to have been tapered and thus it was obvious that a seal was being achieved.
Thanks,
Edde
Just hoping someone can provide some advise.
I am installing the Dynon engine sensors on my Lycoming IO-360 M1B.
The only probe I am unsure about is the oil temperature sensor.
I have installed this into the top port of the spin on oil filter adaptor. The sensor does not have a gasket and easily screwed into the port all the way without any resistance. I have applied some Permatex thread sealant before tightening the probe. Is this sufficient to ensure that it will not leak. All the other fittings that I have installed seemed to have been tapered and thus it was obvious that a seal was being achieved.
Thanks,
Edde