MartySantic
Well Known Member
The CDI needle did not appear on my Dynon HSI display. The CDI needle appeared just fine on the Garmin 496 HSI display.
Called Dynon this morning. To get the CDI needle to appear on the Dynon display, Dynon tech support indicated that a setting has to be changed in the 496. It may be the same for the other Garmin GPS units.
In the 496 setup menu. Start at the Main Screen, Scroll down to SETUP, Scroll right to INTERFACE, Scroll down to Interface Type, Press MENU, as opposed to enter, Go to Advanced -- NMEA Output Setup -- Change it From FAST to NORMAL
Stein confirmed the change and indicated the change has been implemented. Only the early avionics kits were shipped with the incorrect parameter in the GPS.
Called Dynon this morning. To get the CDI needle to appear on the Dynon display, Dynon tech support indicated that a setting has to be changed in the 496. It may be the same for the other Garmin GPS units.
In the 496 setup menu. Start at the Main Screen, Scroll down to SETUP, Scroll right to INTERFACE, Scroll down to Interface Type, Press MENU, as opposed to enter, Go to Advanced -- NMEA Output Setup -- Change it From FAST to NORMAL
Stein confirmed the change and indicated the change has been implemented. Only the early avionics kits were shipped with the incorrect parameter in the GPS.
Last edited: