[647jc]

I'm looking for a picture showing the installation of a Dynon fuel flow sensor preferably on a carburated engine w/gascolator. The device description from Dynon scpecifies a "1/4" female NPT". I assume that means an typical AN816-6D (Tube O.D. 3/8" and a 1/4" thread size).

J.C.

 

[Radomir]

Here's one option:

http://www.repucci.com/bill/images/fuel flow.jpg

PS.. Yes, that'd be the correct fitting for it.

 

[Paul Eastham]

I did something similar, though I bolted the angle to the firewall rather than rivet. Note that the wires are supposed to point upward for correct operation!