RVG8tor
Well Known Member
I need to run my purge return line but before I do I want to find a location for the Flo Scan fuel flow sensor used in the Dynon instruments. There are two large holes for bolting this small item to something but then I thought I have seen it mounted with fittings and just in line with the fuel line, no support provided.
Any RV8 or 8A builder care to share with me where you mounted the flow sensor, and pictures sure would be helpful. If you don't want to post the pictures you can email me with the address in my profile. Thanks for the help
Right now I think I want to make a loop coming out of the boost pump back through the flow sensor then back forward to the firewall bulkhead fitting. The flow would do a large 360 degree reversal coming out of the pump. One thought was to mount the flow sensor right to the bulkhead fitting. The only thing the Dynon instructions say is to make sure it is after the boost pump and filter.
Any RV8 or 8A builder care to share with me where you mounted the flow sensor, and pictures sure would be helpful. If you don't want to post the pictures you can email me with the address in my profile. Thanks for the help
Right now I think I want to make a loop coming out of the boost pump back through the flow sensor then back forward to the firewall bulkhead fitting. The flow would do a large 360 degree reversal coming out of the pump. One thought was to mount the flow sensor right to the bulkhead fitting. The only thing the Dynon instructions say is to make sure it is after the boost pump and filter.