[Chuck May]

I've installed a Dynon 10A in my 7A and would like to know where folks are placing there remote compass and tempature probe?

 

[sprucemoose]

Under the turtledeck, about a foot aft of the baggage bulkhead.

http://home.mindspring.com/~rv6/RV6site/Dynon.htm

 

[Bob Martin]

Dynon

Left wing tip.....rear most.
OAT probe bottom wing skin, next to access panel.
OAT wires into the Remote compass, so has to be close.
This set up worked great for me.

 

[roadrunner20]

Under the turtledeck, about a foot aft of the baggage bulkhead.

http://home.mindspring.com/~rv6/RV6site/Dynon.htm

Same place for me. Works great.

 

[vlittle]

If you mount in rear turtledeck, the OAT probe works well underneath the HS.

Beware, however, that if you have a slider, you need to calibrate the compass with the canopy closed. The steel canopy frame can affect the compass.

 

[Sam Buchanan]

I've installed a Dynon 10A in my 7A and would like to know where folks are placing there remote compass and tempature probe?

Magnetometer is mounted on the little "deck" just under the leading edge of the vertical stab. Wrap it in a plastic bag prior to mounting to make sure no water can drip on it from the stab.

OAT probe is mounted under the horizontal stab. This setup has been flying on my RV-6 for a few years and works very nicely.