Wesflies
Active Member
OK???I?m a bonehead! While installing the Duckworks light kit I drilled the nutplate holes for the lens in the leading edge SKIN . I know, I know?.the instructions say, ?Being careful to NOT drill the nutplate holes in the skin.? Can I just go ahead and fill these #40 holes later when painting? Put a rivets in the holes? Ideas please! I have an order form filled out and ready to send to Vans for a new skin (GRRRRR). I hate to spend the money if it is not needed. If there is any good news here, it is that I started the Duckworks install before the leading edge was riveted.
Wes
RV7A Wings
Woodstock, GA
Wes
RV7A Wings
Woodstock, GA
Last edited: