JurgenRoeland
Well Known Member
Hi,
I'm in the process of rivetting my forward fuselage and side skins to the tailcone and all excited to get to the point of rolling over the canoe.
During rivetting I noticed that I didn't drill the forward tab of the armrest F-720 into the F704 main spar bulkhead. The F704 is not predrilled at this location. I didn't do this yet because I realised the F-704K upright cap strips still needs to be put in place later. This tab in the armrest goes in with a LP4-3 pop rivet because of the impossible access on the inside later.
When did you guys actually drill this hole in the F-704 and install the pop rivet ?
I'm in the process of rivetting my forward fuselage and side skins to the tailcone and all excited to get to the point of rolling over the canoe.
During rivetting I noticed that I didn't drill the forward tab of the armrest F-720 into the F704 main spar bulkhead. The F704 is not predrilled at this location. I didn't do this yet because I realised the F-704K upright cap strips still needs to be put in place later. This tab in the armrest goes in with a LP4-3 pop rivet because of the impossible access on the inside later.
When did you guys actually drill this hole in the F-704 and install the pop rivet ?