Hi all,
After a few decades of radio control building, I am quite fond of my dremel tool. I have been trying unsuccessfully to use it for deburring and fine work on my RV 8. I have tried aluminium oxide stones, and they keep loading up. They get completely covered in aluminium, which I cannot figure out how to get off.
(This is not a great picuture, couldn't figure out how to get my camera to focus any closer).
I am leary of using silicon carbine and am not sure what the dremel sanding drums are made of. What kind of fittings do most people use? Are the sanding drums okay? Any suggestions on cleaning my AlO2 stones?
Thanks,
Michael Wynn
RV 8 Fuselage
San Ramon,CA
After a few decades of radio control building, I am quite fond of my dremel tool. I have been trying unsuccessfully to use it for deburring and fine work on my RV 8. I have tried aluminium oxide stones, and they keep loading up. They get completely covered in aluminium, which I cannot figure out how to get off.
(This is not a great picuture, couldn't figure out how to get my camera to focus any closer).
I am leary of using silicon carbine and am not sure what the dremel sanding drums are made of. What kind of fittings do most people use? Are the sanding drums okay? Any suggestions on cleaning my AlO2 stones?
Thanks,
Michael Wynn
RV 8 Fuselage
San Ramon,CA