theflyboy1
I'm New Here
I am working on the vertical stabilizer and noticed an inconsistancy between the manual, parts, and drawing. The manual and parts agree that the ribs are VS 704, VS 705, etc., however, on drawing 6PP the ribs are referred to as VS 404, VS 405, etc.
I'm 99.9% sure it is just a mistake on the drawing, but I'm looking for that 100% comfort level. Anyone else notice this issue? A search on this site yeilded no similar topics.
Thanks,
I'm 99.9% sure it is just a mistake on the drawing, but I'm looking for that 100% comfort level. Anyone else notice this issue? A search on this site yeilded no similar topics.
Thanks,