Weefle
Well Known Member
Happy New Year everyone!
What a better way to start 2022 than continue working on the doors....said no one ever!
I am using the usual mods...areosport handle, plane around latch and McMaster seals. I haven’t installed the seals yet just working on the 1/4” gap all around.
My question for those who have gone before is.....how much pressure are you experiencing when opening closing the handle when your finally done? When you look at the design of the door closing system it’s all about grabbing the two outside pins and center cam and pulling that door into the bulb seal to crush it. How much pressure are you seeing on your door handle. I seem to have to really reef on the handle to close the door. I can’t see this as being good over the long term.
Any thoughts?
What a better way to start 2022 than continue working on the doors....said no one ever!
I am using the usual mods...areosport handle, plane around latch and McMaster seals. I haven’t installed the seals yet just working on the 1/4” gap all around.
My question for those who have gone before is.....how much pressure are you experiencing when opening closing the handle when your finally done? When you look at the design of the door closing system it’s all about grabbing the two outside pins and center cam and pulling that door into the bulb seal to crush it. How much pressure are you seeing on your door handle. I seem to have to really reef on the handle to close the door. I can’t see this as being good over the long term.
Any thoughts?