Jerry Fischer

Jerry Fischer

Well Known Member
A copy of the isometric or installation drawing for the O-360 baffles?
I ordered and received just the prints (2 Pages) SHOWING THE PARTS BUT NOT THE PAGE WITH THE PARTS ASSEMBLY!:eek: Van's is closed for the rest of the weekend until Tuesday so I can't proceed until I see how they go together. any pictures/drawing emailed to [email protected] would be greatly appreciated.
Thanks for looking
Jerry:eek:
 
O-360 baffles pictures

Jerry,
I don't have the drawings electronically but have several web pages of pictures I took during the fitting and installation if that helps at all. It's an O-360 installation for RV-6A but should be close.

First page shows rough fit at cleco'd together stage:

http://rv6aproject.ckhand.com/FirewallForward/Baffles/Baffles_pg_1.htm

Second page shows more close-ups at same stage:

http://rv6aproject.ckhand.com/FirewallForward/Baffles/baffles_page2.htm

And this page shows some "final" installation shots:

http://rv6aproject.ckhand.com/FirewallForward/Baffles/baffles_pg4.htm

Rough fit:

RV-6AN731CK164.JPG



Bottom left, rough fit:

RV-6AN731CK167.JPG



Bottom right, rough fit:

RV-6AN731CK168.JPG



Painted and riveted:

RV-6AN731CK327.JPG
 
Baffles

I'm still looking for any of the new drawings/instructions for the engine baffles for my O-360. RV6 Bob posted that he emailed me but it must have gotten lost in the ether.I have vans 1993 rv6 version of the 2 parts drawings but no additional hardware/pieces/brackets, etc that would be a complete set of plans and instructions..:confused: I thought I ordered the RV7 baffle plansfor my plane which I have been building since 2007.
Any help will be appreciated.
 
Ive sent two emails to both addresses, the file is 3MB. From my end, it appears that they went through. Do you have any other email addresses that I could try?
 
Drawings

I sent RV6Bob a message to PM me his email address so I can put it in my safe senders list
Thanks,
Jerry
 
You must log in or register to reply here.