HFS
Well Known Member
Here are some yokes (and handle) I made for "close quarters" work, like the last rivet on aileron/flap ribs:
On the left - dimple, on the right - rivet. They will both get into less than 1/4" spaces.
The squeezer handle has been relocated from inline to a 15* offset from "square", much nicer (most of the time) ergonomically.
HFS
YMMV - And probably will.
On the left - dimple, on the right - rivet. They will both get into less than 1/4" spaces.
The squeezer handle has been relocated from inline to a 15* offset from "square", much nicer (most of the time) ergonomically.
HFS
YMMV - And probably will.
