LettersFromFlyoverCountry
Well Known Member
On the RV-12iS instructions, chapter 28, page 2 figure 4, the call-out for WD1211-L&R show different orientations of the Tabs on the drawing that what the actual part shows.
It would appear that either the ID of the drawings are reversed, or the labels on the parts are.
But I need this confirmed before doing anything further (rats!)
The thing is: the part ID on the left and right cylinders are also reversed.
This is highly unusual for Van's, so I suspect I'm missing something obvious. But what?
It's funny how my need for support tends to increase while everyone is at Oshkosh.
It would appear that either the ID of the drawings are reversed, or the labels on the parts are.
But I need this confirmed before doing anything further (rats!)
The thing is: the part ID on the left and right cylinders are also reversed.
This is highly unusual for Van's, so I suspect I'm missing something obvious. But what?
It's funny how my need for support tends to increase while everyone is at Oshkosh.
Last edited: