I ran into a bit of a snag with the plans for the empennage. Page 12-11 (revision 2) step 6 says to dimple the holes in the vertical stabilizer assembly where the empennage gap cover is dimpled and, if desired, finish the dimples with a countersink. I dimpled these holes.
Page 12-12 (revision 1) step 3 says to counter-sink those holes to accept the empennage gap covers.
The nutplate that is called for is a K1000-6. The center hole in that nutplate will not fit over the dimple for the #6 screw.
Is there a nutplate I can find in the kit that will work here, or am I going to have to flatten those dimples out and counter-sink the holes?
Page 12-12 (revision 1) step 3 says to counter-sink those holes to accept the empennage gap covers.
The nutplate that is called for is a K1000-6. The center hole in that nutplate will not fit over the dimple for the #6 screw.
Is there a nutplate I can find in the kit that will work here, or am I going to have to flatten those dimples out and counter-sink the holes?