[Ron Kostus]

Finished my tanks on my 7 about six months ago. I prosealed the access panel , sender and the screws. Left out the cork gasket and rubber donut. Any good ideas that I haven't thought of to cut through the seals without ruining parts? I'm considering dental floss, steel braided fishing line or a really thin knife made from spring steel. Thanks for your ideas !

I'm sure other people with the same problem will benefit from your posts.

 

[Davepar]

I read some post that said heat would help. Best applied only if your tanks have never seen fuel.

 

[LettersFromFlyoverCountry]

I used my wife's hair dryer and the chip chaser.

but the most important item used...was patience.

 

[Dayton Murdock]

Hi All
I used a serrated plastic knife to cut thru proseal

 

[Mel]

I've gone into many tanks that were sealed this way. I use a sharpened putty knife. Works great.