[cnpeters]

I followed Van's template to cut the main gear (9A) holes in the forward bottom skin. The holes overlap the 704 main spar flange a half inch, which means I will need to trim the latter for the main gear weldment to fit. Is this true or did I make a mistake (I double checked the placement of Van's template before cutting)?

 

[scard]

Trim away. You have it correct.

 

[beechrv9a]

Trim the 904

I followed Van's template to cut the main gear (9A) holes in the forward bottom skin. The holes overlap the 704 main spar flange a half inch, which means I will need to trim the latter for the main gear weldment to fit. Is this true or did I make a mistake (I double checked the placement of Van's template before cutting)?

After trimming, I ended up with only 4 of the double flush rivets (supposed to be 5) on the outside edge of the 976 forward bottom skin to the 904 forward bulkhead.

 

[mikehoover]

Picture of mine

Here is a link to a photo of one of my gear leg holes. Looks like I trimmed it pretty good; can't tell but it looks like I trimmed at least thru a rivet hole on the main spar flange:

http://www.aclog.com/rv-9a/images/Fuselage/DCP_2705.JPG

Hope this helps!

 

[cnpeters]

Thanks, guys. After I posted this, I also found the Van's reference on one of the plans that mentioned the need to trim the flange.