Folks,
I am fitting a Cummins aluminium spun spinner to my almost completed RV6.
The Cummins installation instructions do not require the spinner to be checked for "tracking" of the nose as the Vans instructions do. This is presumably because there is no need to trim the aft edge of the Cummins spinners, whereas the Vans spinners need trimming.
Can those of you who have fitted these spinners please advise whether they bothered checking the tracking prior to drilling the spinner backplate & fwd plate.
Thank You
Graham
New Zealand.
I am fitting a Cummins aluminium spun spinner to my almost completed RV6.
The Cummins installation instructions do not require the spinner to be checked for "tracking" of the nose as the Vans instructions do. This is presumably because there is no need to trim the aft edge of the Cummins spinners, whereas the Vans spinners need trimming.
Can those of you who have fitted these spinners please advise whether they bothered checking the tracking prior to drilling the spinner backplate & fwd plate.
Thank You
Graham
New Zealand.