I have a question about the journal cut crush plate used with wood props.
My plate is a little buggered up on 3 holes that do not stop the bolt from turning anymore. Instead of buying a new one for 69.00 from Vans I'd like to redrill the plate holes 15 degrees off from the original ones. I think this is a-ok but just wanted to run this by the forum.
My plate is a little buggered up on 3 holes that do not stop the bolt from turning anymore. Instead of buying a new one for 69.00 from Vans I'd like to redrill the plate holes 15 degrees off from the original ones. I think this is a-ok but just wanted to run this by the forum.
